file does not by itself cause the resulting executable to be covered by this file and link it with other files to produce an executable, this templates or use macros or inline functions from this file, or you compile As a special exception, you may use this file as part of a free software Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA along with this program if not, write to the Free Software You should have received a copy of the GNU General Public License GNU General Public License for more details. MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. but WITHOUT ANY WARRANTY without even the implied warranty of This program is distributed in the hope that it will be useful, the Free Software Foundation either version 2 of the License, or it under the terms of the GNU General Public License as published by Arduino is free software you can redistribute it and/or modify Developed by Zach Eveland, Blacklabel Development, Inc. Until then, here’s the source (can’t load it as code at the moment either…). When I can upload the file I’ll tag a copy here (the forum only accepts image files at the moment … sigh ) Once I had finished updating the appropriate places in the file I then Updated the drivers for the unknown device and all became well! Note that the new device was an unsigned device, so the usual warning messages about installing unsigned drivers appeared. To solve this, I edited the arduino.inf file and added another device called the ‘mangOH DV2 Arduino Leonardo’. This was the reason that Windows could not enumerate the device. It was this second enumeration that was failing on my Win7 PC.Īfter a lot of scratching around, I found that the USB VID/PID value returned from the mangOH Leonardo when in CDC mode DID NOT MATCH the USB VID/PID string in the official Arduino provided arduino.inf file (found in C:\Program Files(x86)\Arduino\drivers). On initial boot the Leonardo enumerates on the USB as a bootloader device, then after about 10 seconds or so it then re-enumerates as either a CDC (serial port) device, or a HID (mouse/keyboard) device. The Arduino as implemented on the DV2 board is a ‘Leonardo’ - which does all communications with the host via USB. I did notice that there was an ‘Arduino Leonardo Bootloader’ device appear in the Device Manager->Ports section for a brief moment (about 10 seconds or so) after the Arduino had been rebooted … so I knew that the connection between the PC and mangOH board was OK. When I connected to the Arduino (via CN330), Windows New Hardware wizard failed to find drivers for the Arduino, there was no com port in the Windows Device Manager (just an ‘Other Device’ with an error), and the Arduino IDE could not connect to the mangOH board. Sketch developed using an Arduino Uno board I KNOW THE DV2 BOARD IS DEPRECATED … BUT THERE’S MORE THAN A FEW OUT THERE SO I EXPECT THIS MAY BE USEFULĪrduino IDE 1.6.9 (check ‘ install the USB drivers’ when installing) A couple of brief notes about how to get started with the Arduino on the mangOH DV2 board.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |